What is the best design for this project? - best paper boat to hold pennies
I have a boat for a scientific project. I can only use three.
1. A 5x5 inch film.
2. Sorbets. (find the cheapest restaurants in the newspaper.)
3. Hot glue.
I need to find the best model for keeping the boat too much weight in parts as possible.
Thank you for your time in advance.
Friday, February 19, 2010
Best Paper Boat To Hold Pennies What Is The Best Design For This Project?
Subscribe to:
Post Comments (Atom)
The weight of the boat, "" is equal to the weight of water displaced. Because you are not deposited in a rough sea, a deep keel is not required to make.
ReplyDeleteI want to make a series of 5x5. Cut the straw is closed to 5 cm and glue both ends. Organize and share a series of straw in one direction, gluing, then another layer of 90 degrees in the first place to stick together and the first layer. Keep going alternately to the dregs, or straws reach the border. Make sure each piece of straw is sealed so that no water can penetrate. Use slides 5x5 deck, while the layers of straw. You can give a volume of straw around the edge of the bridge, with more depth, more contained "load" - the sub. Good luck.
Well ... if there is no limit to the number of servings that could be used as one million will be used to build a raft, you connect the ends with hot glue.
ReplyDeleteBut if you just say, try 1 straw then use them all.
Just tested. So I just made of aluminum flakes.
I took a stack of about 12 cents you put the battery on the side in the middle of the road (used only as a form). Then I wrapped the foil around the stack. The ends can with hot glue and two halves of the straw can be secured will be inserted on the sides of the foil pouch. In addition, the ends must be covered.
If it fails, it may be more of a trampoline "style boat that holds the sheet flat and the line edges sealed with straw